Results 11 to 13 of 13
-
09-08-2015, 10:57 AM #11
I also wanted to go with the TAZ 5... specially after seeing all the stuff this guy makes with them...
https://www.youtube.com/channel/UCUb...50Y_7KmfCXKohA
But budget was an issue... being new to 3D Printing I wanted something less expensive to wet my feet with...
Anyway, no experience with either one of the choices listed, but I would have gone TAZ 5 as well. Congratulations!!Last edited by wachuko; 09-08-2015 at 11:12 AM.
-
09-08-2015, 01:56 PM #12
- Join Date
- Jan 2015
- Posts
- 445
he makes some awesome stuff but my concern is i havent seen super nice quality prints roll off the taz.. they seem not great... unless someone can share otherwise
-
09-08-2015, 02:07 PM #13
- Join Date
- Aug 2015
- Location
- Carpinteria, CA
- Posts
- 5
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion