Results 1 to 10 of 15
Threaded View
-
09-06-2015, 05:14 AM #3
Could be a lens issue.
Not sure about the reference point though. My test above is with one scan only. The software needs reference points to align 2 scans, but i don't think it needs them for a specific scan. Actually, it got its own black and white stripes.
This morning i made a long 2 hours scan, carefully cutting each of these curled corners ( i could see the curling on most scan actually now that I'm aware of it), it got pretty good, until the moment i click complete and the software crashed on me before finishing the mesh . What a ç%/%ç problem this is. I seriously hope Shining3d is adressing this problem. Lost my morning on this. Frustrating.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help