Results 1 to 7 of 7
Thread: Corner curling up
Threaded View
-
09-05-2015, 09:45 AM #3
- Join Date
- Feb 2015
- Posts
- 371
PLA. I tried a different slicer and it is better. Matter Control works a lot better for this but has issues in other areas. Every Slic3r seems to be a compromise.
I did get a little bit of oozing which is very evident when I set it to random seams. I am using a e3dv6 with 1.5mm retractions. The retraction is a bit on the hight side for that hotend i think. Most of the ooze is after a travel move. I think there is just too much pressure in the melt zone. I am thinking a 1.75 setup may be in my future.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help