Results 1 to 10 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
09-05-2015, 02:55 AM #10
Well... I need to research more the configuration of Simplify3D for this printer.... AND was not aware that the simple software that comes with the printer, already has raft/support capabilities...
I need to look up all the setting currently in ReplicatorG and use those to start the configuration in Simplify3D
Trying the same part again... with ReplicatorG and Support enabled...
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion