Results 1 to 4 of 4
Thread: Prusa i3v Y-Axis Issue
Threaded View
-
09-01-2015, 06:59 PM #1
- Join Date
- Sep 2015
- Posts
- 2
Prusa i3v Y-Axis Issue
Hi,
I have a Makerfarm Prusa i3v that works wonderfully and hasn't given me any problems until just recently. My printer starts and works fine (before I begin running a print), but once I start a print the y-axis stops moving and will not start even after the print is cancelled. It happened once before but I restarted the printer and came back a few hours later only to find it running smoothly again, but now it's begun to act up and I can't figure out the reason why. Hope you can help.
Thanks,
Bia
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion