Results 1 to 10 of 10
Thread: New software 1.5
Threaded View
-
08-31-2015, 02:17 PM #8
well, did not succeed to re-use these files:
ImgL.txt
ImgR.txt
ImgP.txt
CalibraParam.txt
The software says i need to run a calibration. So i deleted the 4 files, re-started the soft, did the calibration, and the same 4 files re-appeared after. I did not compare their content, there must be a flag saying they are from a previous version i guess. Would be easier if Alfred tells us if it's possible or not.
But indeed a few new options are there in 1.5, thanks Shining3d. Could not see any change in scanning accuracy though, but Shining3d did not claim this AFAIK.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion