Results 1 to 10 of 10
Thread: New software 1.5
Threaded View
-
08-31-2015, 09:44 AM #2
Downloaded and trying to test at the moment, but needs calibrating, as well as the V1.4 uninstalling.
Using turntable for first retest scan... and you guys have added a new action,
simplicify.jpg
so that a broken scan volume will get omitted if you say OK... on the turntable the overhang casts a shadow, so on a single pass the mesh is incomplete, and it gets truncated like this...much better.
scab.jpg
It does tend to crash more at the end of the meshing, but i don't know if it's because I am not "simplifying"
BTW, it now saves as an .obj file too (y)
MikeLast edited by 24c; 08-31-2015 at 10:43 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion