Originally Posted by
ffvader
i'm about 4-5 weeks ahead of you with my printer..
i used repg for about a day, then switched to slic3r and finally to simplify3d.
at first i though slic3r was better, but i stuck with using s3d and my prints are turning out great.
i would suggest you just stick with it..very few people don't rave about it.
No trying to be a smart aleck but....
my suggestions.
get some glass - why?
use hairspray - why?
pull that blue tape off your build plate. Again why? It's sticking reliably with seems to be an issue for a lot of people.
for thinner walls, print more infill. try 30-40% - how?
In s3d and slic3r there is a "detect thin walls" setting. Where?
not sure about repg
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help