Subscribe to Our Newsletter Advertise
Close



Results 1 to 5 of 5

Threaded View

  1. 08-16-2015, 06:53 AM #2
    AmyInNH
    AmyInNH is offline
    Student
    Join Date
    May 2014
    Posts
    35
    Hello Ghosty. Any updates on this? I got 6 good weeks out of FF's Blue Heat Plate Print Tape but it is a bear to get off the bed when time to replace, 2 hours and a lot of muscle. With many things to print at a faster rate, I can't see doing this every couple of weeks. I'm hoping you found a clean answer in the PRINTinZ Zebra Built Plate.
    Last edited by AmyInNH; 08-16-2015 at 07:03 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules