Results 1 to 10 of 29
Threaded View
-
08-16-2015, 02:05 AM #4
Hey Mike,
i think i had the same also.
I understand the projector does not display the black and white stripes on the object, right ?
If so, it happened to me under two occasions:
- first after the upgrade to version 1.4 of Einscan software. What i did not know is that we have to re-do a calibration after this upgrade. If you don't do it, you have the problem you descirbe. But i understand you managed to calibrate.
- second time was because my main Windows screen (my desktop) was not defined for 800x600 resolution but higher. This had the effect of "pushing" the black&white stripes beyond the projector second screen. Make sure your projector resolution AND your desktop resolution are both in 800x600. AFter you've done so, place a white sheet about 60cm in front of your projector to see what is displayed. If you move your mouse on the projector screen, you should see it right away when you exit your desktop screen through the right with your mouse. Mine did not show right away, it was much further away.
If this fails, try to contact tech support, thread here:
http://3dprintboard.com/showthread.p...lem-Contact-Me
let us know how it goes.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help