Results 1 to 10 of 18
Thread: Wireless connection solution?
Hybrid View
-
08-16-2015, 01:48 AM #1
- Join Date
- May 2014
- Posts
- 67
Sorry if I'm late to the discussion; I found out this is the correct forum where everyone talks about Flashforge / Makerbot clones (I have a CTC). I've had success using Astroprint (http://astroprint.com). It's still being developed and doesn't seem as advanced as Octoprint, but between the two, it's the one that effortlessly installed for me on a Raspberry Pi. Acts as a go-between your printer and pc, and you can easily monitor the prints via webcam wireless and print from wherever.
-
08-16-2015, 05:48 AM #2
-
08-17-2015, 12:36 AM #3
- Join Date
- May 2014
- Posts
- 67
If you have a Raspberry Pi, you can install the Astroprint firmware onto SD card. Follow the instructions on their website, it's pretty simple to setup. You don't need a monitor or keyboard or mouse just insert a properly formatted SD card with the Astroprint software, connect to the WiFi Access Point it creates and go from there.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion