Results 1 to 6 of 6
Thread: Setting up Cura for i3v
Threaded View
-
08-13-2015, 12:09 PM #4
- Join Date
- Jul 2015
- Posts
- 27
USarmyaircav and Printbus thanks for the responses. First I want to apologize for spreading this over multiple threads. As you two responded I dug up an earlier post of Printbus's here: http://3dprintboard.com/showthread.p...settings/page2 asking questions about retraction settings.
USarmyaircav I have now looked at Printbus's thread where you got your Cura settings.
Looking at Printbus's Repetier/Cura settings I see retraction distance set at 1.5 mm and minimum travel before retract at 4 mm. Were these proven sufficient?Last edited by CoffeeCup; 08-14-2015 at 03:33 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help