Results 1 to 10 of 30
Thread: Printer to replace Z18
Threaded View
-
08-10-2015, 01:17 PM #26
- Join Date
- Aug 2014
- Location
- Montreal, Quebec
- Posts
- 576
Why after watching the 3 link, it does not feel 200mm/s print?
Because for me it is clearly between 50 to 100mm/s. The perimeter print is too slow for being 200, can't say about the infil, since the thickness is not that big.
But I am curious about your double extruder setting, did you use paper to calibrate both height?
Oh and dont upload pic on this forum, cuz it sucks lol. Upload on some 3D party hosting and link them, it is far better.Last edited by richardphat; 08-10-2015 at 01:23 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion