Results 1 to 10 of 30
Thread: Printer to replace Z18
Threaded View
-
07-28-2015, 01:02 AM #18
Yes, I mean for NinjaFlex filament printing, a over 70 mm/s speed is too fast.
For normal printing, the highest printing speed I have tried is 200 mm/s.
In the slice software I can set it up to 300 mm/s, but I don't think at that speed the printer will give good results...
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion