Results 1 to 10 of 56
Threaded View
-
07-12-2015, 08:31 PM #11
No worries about not answering the questions. Naturally I assumed that your team is trying to make the best possible prints and would be pursuing that goal if you could.
The question was more to catalyse some thinking. I found the stairs of the purple rook to look very glassy, and thought it had just been a question of layers.
It might simply be that the glass columns were printed from high up and were straight, so the laser was interacting less with surrounding resin and produced a consistent surface as it went.
It could simply be a question with laser power, spot size, layer numbers, and print time. If you print it slow and take your time it may come out better?
In any case, Im already super impressed with the prints so far, and with better calibration for accurate parts, the peachy will have surpassed my expectations (which were still high) by far.
-UD
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion