Results 1 to 3 of 3
-
07-11-2015, 01:02 PM #1
- Join Date
- Feb 2015
- Posts
- 371
How do I get better overhang performance?
In my quest for better printing I am moving on to another hurdle to tackle. Better over hang performance. The recent part I tried to print was about 40 degrees from the horizontal. Some of the edges print fine, some are terrible.
Just looking for some advice on what I can change to get better overhangs.
IMG_3275.jpgIMG_3276.jpgIMG_3277.jpgIMG_3278.jpg
-
07-11-2015, 01:15 PM #2
- Join Date
- Oct 2014
- Posts
- 8
I would try slowing the speed down, and using some cooling fans.
-
07-11-2015, 01:50 PM #3
- Join Date
- Feb 2015
- Posts
- 371
Right now my external perimeters are at 30mm/s. I will see what I can do about a cooling fan but I'd like to avoid that if possible.
Resin has changed after...
06-18-2024, 10:34 AM in General 3D Printing Discussion