Results 1 to 10 of 56
Threaded View
-
07-08-2015, 12:12 AM #6
- Join Date
- May 2014
- Location
- hiding in your pillow
- Posts
- 52
When dealing with enamel coated wire, I've always found it is easiest to just burn the enamel off the end with a lighter... then gently sand the burned area to expose bare copper. Of course if the wire is too fine, you might melt it by accident.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion