Results 1 to 10 of 56
Threaded View
-
07-08-2015, 12:12 AM #6
- Join Date
- May 2014
- Location
- hiding in your pillow
- Posts
- 52
When dealing with enamel coated wire, I've always found it is easiest to just burn the enamel off the end with a lighter... then gently sand the burned area to expose bare copper. Of course if the wire is too fine, you might melt it by accident.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)