Results 1 to 8 of 8
Threaded View
-
07-05-2015, 11:32 AM #7
Actually, it's not the scan that fails, but the alignment.
I can scan properly in free scan mode, the first scans comes out nicely, the second one as well, but when i ask the system to align them, this is where it starts to get ugly.
Advice on proper alignment would be really needed here.Last edited by Hugues; 07-05-2015 at 02:47 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion