Results 1 to 2 of 2
-
07-01-2015, 12:00 PM #1
Einscan software does not start anymore ?! / SOLVED
ok,
I'm running Windows 8 64 bit under bootcamp on a Macbook pro.
I managed to run the calibration procedure without any problem.
I manage to start a scan, i could see the white/black stripes, there was around 20 sec left to the full scan on the turntable, then the Einscan application crashed, there was only a window saying it stopped running and a CLOSE button. So i clicked close, no choice.
Since then, i cannot start the Einscan software anymore. I rebooted, disconnected everything, uninstalled and re-installed the software successfully, but the software does not start anymore. It does nothing after clicking on the icon. Nothing appears in the Task Manager.
No clue what to do,
too bad, i was 20 sec away from my first scan.Last edited by Hugues; 07-01-2015 at 01:11 PM.
-
07-01-2015, 12:32 PM #2
solved,
i was running out of disk space, cleared, and now i'm scanning, cool.
should be able to show my first scan soon. An orange.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion