Results 1 to 10 of 18
Thread: Simplify3D settings?
Hybrid View
-
06-23-2015, 08:39 PM #1
- Join Date
- Jan 2015
- Posts
- 306
You could also fudge your print by putting a 0.4mm nozzle, leave that alone, and boost your flow to something like 175% and it will lay down a very wide single layer. This will be tricky with ABS since the W/T ratio is high if you do that, and that may cause a lot of internal stress. I sometimes go this route.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help