Results 11 to 15 of 15
-
06-23-2015, 02:05 AM #11
- Join Date
- Sep 2014
- Posts
- 28
Thanks for your response Sinful.
Ya, I only plugged in that fan for a few seconds. It didn't work. It's a 12v fan. I already ordered the fan form makerbot.
I tried to let a the printer run and I'm back to getting extruding problems. Randomly starts extruding less during the print and has a tocking sound. The moter couldnt push or pull the filament.
-
06-23-2015, 04:45 AM #12
- Join Date
- Sep 2014
- Posts
- 19
without a right fan you wont be able to avoid constant extruder clogs. Please make sure you have installed new fan with the sticker looking inside to the heat sink and try again.
-
06-23-2015, 02:30 PM #13800K hours.
I guess that could wear a motor out :-)
-
06-23-2015, 02:51 PM #14
-
06-24-2015, 06:34 PM #15
- Join Date
- Sep 2014
- Posts
- 28
Got my new fan today. I replaced the nozzle with a new one. Torched the one I took off. And with the new fan, my Replicator 2 seems to be printing like the beast that it is so far. Extruder motor warm as usual.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help