Results 1 to 3 of 3
Thread: Print One at a Time
-
05-02-2015, 07:22 PM #1
- Join Date
- Jun 2014
- Posts
- 8
Print One at a Time
Is there a way to get the MakerWare to print one item start to finish before move on to the next when multiple items are set to print on the build plate? I know you can do this with Cura. I haven't tried this slicer out yet, I know it works with some Makerbots, not sure if it works with the 2x though.
-
06-22-2015, 01:28 PM #2
- Join Date
- Jun 2015
- Posts
- 11
i dont think you can. not with the default makerware slicer anyway. if your slicer can output 3xg files you probably can use that one to do it, but watch out for the size of the dual extruders.
-
06-26-2015, 01:13 PM #3
- Join Date
- Mar 2015
- Posts
- 2
Correct about the defauilt slicer. Also, on my 2X the hardware prevents this unless your print is very short. Otherwise the rails the extruder rides on will collide with previous parts. I tried this already...
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help