Results 1 to 10 of 321
Thread: Flashforge 3D Creator forum.
Threaded View
-
06-18-2015, 04:44 PM #11
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Load filament with it in bits and watch the stepper doing whatever it does. If that turns smoothly then it is down to heaters and/or plastic but if that dithers and vibrates it is a broken wire or driver. Swap the plugs if you have two extruders see if the other motor is smooth.
Stepper motors never break unless you pull them apart, then they never work again.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help