Results 1 to 8 of 8
Thread: XTC 3D and a solvent (thinner)
Threaded View
-
06-08-2015, 06:39 AM #6
denetured alcohol would be the SENSIBLE solvent of choice. It's considerably less toxic than acetone and if you've got any left over you can dilute it down (a lot) with orange juice for a cocktail :-)
Also, not sure if alcohol will dissolve abs, if it doesn't then it should give you a better finish than acetone based xtc.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion