Results 1 to 10 of 40
Threaded View
-
06-05-2015, 10:37 AM #12
Magic, eh? Been a while since I talked to the coven. I wonder if they still have my wand...
Pretty sure there aren't any naked edges or bad surfaces on the model. Usually, if there's a bad surface or naked edge on the model, the problem areas occur in the same spot every print, in the vicinity of the bad surface or naked edge. I don't think that's it but I will double-check with a few third-party programs just to make sure.
Bolin? Do you mean Boolean? Yes I used the Boolean Union command in Rhino to make the model into one watertight mesh for printing.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)