Results 11 to 20 of 21
Thread: 3D Business Cards Printing
-
06-02-2015, 08:01 AM #11
Felt inspired by the thread and finally had some time to make my own business cards
Half printed, half laser cut and engraved.
I printed the frame with frosty white ABS and tried to design it with rails on the sides so I could easily change the ornament on it (the flower and the gears) or the acrylic part inside. The ornament has a support that slides on the rail. Image attached.
3d printed business cards.jpgPrintare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
-
06-02-2015, 03:22 PM #12
is it me or has this thread become somewhere to just advertise your business while pretending to be an actual forum member ?
Nah it's not just me :-)
-
06-02-2015, 03:46 PM #13
-
06-02-2015, 05:39 PM #14
Or 3D print your own business card...
CP3D bizcard.jpg
-
06-02-2015, 11:13 PM #15
You don't mean Car3less, right? (That is who's post you ended up after...)
Is this the same person as in this thread?
https://github.com/fmalpartida?tab=activity
I'm bad with faces. But if it is the same person... She deserves to get cut a lot of slack here!Last edited by Roxy; 06-02-2015 at 11:22 PM.
-
06-03-2015, 06:11 AM #16
oh hell no not car3less - There are a bunch of posters with 1 or 2 posts who say: 'I bought cards from these people'.
And we're expected to believe they're not from the company itself :-)
-
06-03-2015, 08:25 AM #17
thanks I needed them 2 weeks ago for a 3d printing conference in Abu Dhabi, that was canceled in the end. Lucky me, because I had time to print only 2 business cards
No one could see them. So... as there were not too many printed business cards around here I said to share. ))Printare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
-
06-03-2015, 08:33 AM #18
francfalco
what is the size of the letters on the business card?
Roxy
you are very bad at faces. need more pictures of me? :PPrintare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
-
06-04-2015, 01:58 PM #19
[QUOTE=car3less;59629]francfalco
what is the size of the letters on the business card?
smallest letter cap height is about 7mm
That card is the first test - printed at 0.2
I've also printed at 0.06 and slow, remove the noticeable stepping completely, but i'll need a smaller nozzle to get the letter faces any sharper
-
06-07-2015, 06:19 AM #20
they look nice. I tried to print some text with 5mm height, but didn't go so well.
Printare 3D Bucuresti
Any sufficiently advanced technology is indistinguishable from magic. Arthur C. Clarke
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help