Results 1 to 10 of 29
Hybrid View
-
06-02-2015, 02:14 PM #1
The tolerance between the filament drive gear and plastic is much tighter. The filament is fully supported after the drive gear.
The stock plastic is 4 pieces, and 3 screws. This design is 2 plastic pieces and 1 screw. I also beefed up the preload on the spring to have more pressure on the flex filament.
There isn't any PTFE in the feed mechanism.
-
06-02-2015, 02:39 PM #2
- Join Date
- Mar 2015
- Location
- San Diego, CA
- Posts
- 107
-
06-04-2015, 01:44 PM #3
- Join Date
- Mar 2015
- Location
- San Diego, CA
- Posts
- 107
What do you think about including a wire brush to continuously scrub the drive gear?
http://www.ebay.com/itm/3-pcs-made-i...-/301647740867
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion