Results 1 to 10 of 16
Threaded View
-
06-01-2015, 11:48 AM #5
10% in the corners. I put a small square in each corner and the ones in the bottom corners are rectangles by now. See images. It should have been flat with a small fillet. The one on the left is empty on the inside, the one in the right has a 15% fill but still curls op on the corner. On a third attempt even the brim curled up.
556999bbd2434.JPG
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion