Results 1 to 10 of 22
Threaded View
-
05-30-2015, 04:33 AM #10
- Join Date
- Nov 2014
- Location
- Brevard, NC
- Posts
- 182
I changed this to match the similar style change I did for the X-motor taking out the upper & lower right holes. This also leaves the notch in the lower left for those using the notch for the z-endstop micro adjust like I am. This symmetry is carried to the upper right so it does not really look like a notch anymore. The ledge on the outer top & bottom start on that curve about 6.5mm above & below the alum. extrusion so it should miss the X-limit switch for those that have it still on that side like I do. Here is a photo of the current design. I hope to print it today.X-IdlerPlate_rev8.jpg
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion