Results 1 to 2 of 2
Thread: Help with a pseudo-Form1
Threaded View
-
05-24-2015, 12:19 PM #2
- Join Date
- Jan 2014
- Location
- Oakland, CA
- Posts
- 935
I've had this problem
with the real Form1+. Try removing the build platform, cleaning it with isopropynol, and lightly sanding the aluminum with a sanding block, being careful to remove the resulting grit and oxides with more isopropyl. The other thing to try is increasing the preload against the tank; that's in Help/fine tuning. You can get it to press a little harder by lowering the platform, which seems to do a good thing. Also, positioning the prints so they're closer to the hinge side can help.
Andrew Werby
www.computersculpture.com
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion