3d Printing advice. minimum sizing.

[ricocacciatore]

Hi, I'm looking to print a model via plaster or SLA. I have attached one of the files to this thread ( this is one of five that will come together to produce a sectional model as per the image attached),
as you can see the batons are quite thin. Are these strong enough to print? If not how wide would they need to be?

Thanks in advance

Rico

Screen Shot 2015-05-16 at 14.09.20.jpg

File here: https://3dhubs.s3-eu-west-1.amazonaw...1%29_fixed.stl
MODEL%20%28Cut%201%29_fixed.stl

[curious aardvark]

how big is the model ?
looks like it should print via sla fairly easiy.

[ricocacciatore]

I have had to chop it into 5 pieces to fix a 125mm square print bed. The batons are 1mm in diameter