Results 1 to 1 of 1
-
05-14-2015, 10:18 PM #1
Hollow Tubes Inside Part Filling In
I have a part which has some air passages in it, they are .07" in diameter and run the profile of the part. See wire-frame attached. O am using Simplify3D, and have adjusted settings as to ignore this small of a space, and the wire-frame with infill on the preview is not showing the tubes being filled in. Any suggestions?
Screenshot - 15_05_07 , 11_47_21 PM.jpg
Also check the item out on Thingverse at http://www.thingiverse.com/thing:813434
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)