Results 1 to 1 of 1
Thread: Aluminium rod for Rostock?
-
05-05-2015, 08:55 AM #1
Aluminium rod for Rostock?
Hey guys. I am going to build a Rostock printer and I found these rods: http://www.ebay.com.au/itm/Aluminium...item1c33ac0b46 I was wondering if it would be ok for what I need it for?
I also found these motors: http://www.ebay.com.au/itm/LearCNC-5...torefresh=true will they be good to use?
Thanks.Last edited by TehStranger; 05-05-2015 at 10:07 PM.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion