Results 1 to 2 of 2
-
05-04-2015, 02:12 AM #1
Design advice (engineering) for beginners
A very good article from Philippe :
http://www.spiderbot.eu/en/blog/desi...e-advises.html
-
05-04-2015, 06:26 AM #2If you need accuracy on the holes, always design the holes with a slightly smaller diameter and plan to re-drill.
Also some of the things he says are obviously printer and slicer dependant. Most of the curves he says are bad, I could print with no problems.
New Here, don't print but need a...
06-20-2024, 12:18 PM in General 3D Printing Discussion