Results 1 to 9 of 9
Thread: Warping with raft
Threaded View
-
05-01-2015, 04:39 PM #8
- Join Date
- Apr 2015
- Location
- Northern Ohio
- Posts
- 198
If you are using that then there are some issues. I cannot get my parts off that material without almost breaking them. The leveling is a start as it sets the distance from the bed. What slicer are you using? If you can set the bed temp to 110 for the first couple of layers then back it down to 100. Same for the extruder. Start at 230C and then back it down to 220 or so. You have to play with a new spool to figure it out. I run a 90% first layer height with 125% width
ABS and other materials vary with color and manufacturer.I have a couple of small test parts that I created difficult geometry for knowing that they will work for larger builds due to their difficulty. When I load a new spool I run these parts to see where I stand settings wise for that roll.
These things can help with the leveling
http://www.amazon.com/JW-Winco-Knurl...words=M3+knobs
You really only need a .004 from what I found but I use them for other things.
http://www.amazon.com/Precision-Bran...l+feeler+gauge
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help