Results 1 to 9 of 9
Thread: Warping with raft
Threaded View
-
05-01-2015, 09:21 AM #5
I will check mine every 5 or 6 prints. it just so happens that I had cleaned the bottom of my machine and had bumped one of the wing nuts and knocked it out. Does not take much. I did not check the bed after I bumped it and it had knocked it out by about .3 mm. I say check it often.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion