Results 1 to 1 of 1
Thread: Cranioplasty and 3D Printing
-
05-01-2015, 08:32 AM #1
Cranioplasty and 3D Printing
Dr. Ivan Ulianovsky worked with neurosurgeons at the Vologda Regional Hospital in Russia after they approached him for assistance in creating a mold for a cranioplasty in order to fabricate an implant for a patient who, following a traumatic injury, possessed extensive defects in his skull. Rather than opt for more traditional titanium for the implant, Dr. Ulianovsky worked with Protakril-M, a cold-cure acrylic powder, which would require a precise mold. Following a CT scan, a 3D model was created to map the patient's skull and produce a physical model. This approach proved successful, and the patient is recovering. Read the full article for details about this procedure: http://3dprint.com/61320/cranioplasty-3d-printed-molds/
Below is a photo of the 3D printed molds and Protakril-M implant:
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help