Results 11 to 12 of 12
Thread: Layer fan causing poor prints???
-
04-27-2015, 09:11 PM #11
- Join Date
- Jan 2015
- Posts
- 445
thats interesting... the outlet nozzle on the one i printed is pretty good size... not tiny like some of them. im getting some decent air flow. I tend to think its a factor of too much flow vs too little. Ill run some bridging tests or something to figure it out... it bugs me though
thanks
-
04-27-2015, 09:22 PM #12
- Join Date
- Nov 2014
- Posts
- 61
Ive just recently started printing in pla and have been using the C42's extended fan shroud with the makerfarm fan. It doesn't blow a lot of air over the printed part but I haven't noticed any print quality issues. Im actually rather impressed with pla and might start using it instead of abs. Abs gives me layer separation issues for larger prints.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion