Results 11 to 12 of 12
Thread: Layer fan causing poor prints???
-
04-27-2015, 09:11 PM #11
- Join Date
- Jan 2015
- Posts
- 445
thats interesting... the outlet nozzle on the one i printed is pretty good size... not tiny like some of them. im getting some decent air flow. I tend to think its a factor of too much flow vs too little. Ill run some bridging tests or something to figure it out... it bugs me though
thanks
-
04-27-2015, 09:22 PM #12
- Join Date
- Nov 2014
- Posts
- 61
Ive just recently started printing in pla and have been using the C42's extended fan shroud with the makerfarm fan. It doesn't blow a lot of air over the printed part but I haven't noticed any print quality issues. Im actually rather impressed with pla and might start using it instead of abs. Abs gives me layer separation issues for larger prints.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion