Results 1 to 10 of 21
Thread: Solenoid for Z probing
Threaded View
-
04-26-2015, 01:50 PM #6
Well... I don't know off the top of my head. I would have to have schematics and more details from you. But here is what I can tell you off the top of my head. Most (if not all???) of the GPIO (General Purpose Input Output) pins can be configured as input or output. The pins that can do PWM are most likely not GPIO pins. They are even more flexible than GPIO pins. My guess is they can be configured to be just plain, stupid, simple Input or Output. If so... You can just use the same pin in a crippled mode.
But otherwise, you should be able to connect to some other GPIO pin and say it is output, and just set it high or low as needed.Last edited by Roxy; 04-26-2015 at 02:09 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion