I printed all the parts in PLA at .2 infill to test for fit today. I plan to print the final part in ABS. I am getting some PETG plastic in a couple of days, so I may see how this prints with that. It is fitting pretty good. The plastic weight at .2 infill is 5.6oz for all the plastic & 10.2oz after I added all the hardware. I am printing on buildtak surface which holds it down pretty good, but the outside corners lifted a little, so I probably need to add some ears to those corners.IMG_7271_800x600.jpgIMG_7272_800x600.jpg