Results 1 to 10 of 14
Thread: CTC clone help needed
Threaded View
-
04-15-2015, 07:23 PM #9
- Join Date
- Apr 2015
- Posts
- 25
It's hard to see in the pictures but in the top left corner is where the temperature sensor wires connect. These wires are attached to the hot end with a screw, each attachment screw has two wires that run down and attach to the board. I have ohmed them out and they are not "open".
I have been told that this is the "old" way, the newer ones have a little sensor that is inserted/attached to the hot end. My unit is defiantly the "old" system.
On the bottom row of green plugs, just above the third plug a small red LED lights up continually. The word "overheat" is printed under it and stays on even with all the plug in connectors removed from the board.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help