Results 1 to 6 of 6
-
04-04-2015, 06:37 PM #1
- Join Date
- Apr 2015
- Posts
- 1
Change heated bed temp mid print?
Hello
did a search but couldnt find anything specific on this.
I want to see if I can lower the temp of the heated bed on my CTC dual printer( FF Creator knockoff (has Sailfish 0040r28)) using RepG MID PRINT
My prints have been warping off the edges, and i know my adhesion is good because it is really hard to remove after printing.
Im trying to print the calibration print that CRTLVTEST has on thingiverse.
-
04-08-2015, 12:30 AM #2
- Join Date
- Apr 2015
- Posts
- 8
I don't know about RepG since I use Simplify3D, but... I had warping issues with my part as well (it's 3" x 4" flat) and the corners would always warp. I now start my bed temp at 115C and after 5 layers I drop it to 100C and I get pretty close to ZERO warp.
-
04-08-2015, 11:03 AM #3
- Join Date
- Mar 2015
- Location
- San Diego, CA
- Posts
- 107
-
04-08-2015, 04:00 PM #4
- Join Date
- Apr 2015
- Posts
- 8
-
04-09-2015, 06:36 AM #5
-
04-13-2015, 08:06 PM #6
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion