Results 1 to 6 of 6
Thread: Manual bed leveling question.
Threaded View
-
04-10-2015, 03:36 PM #1
- Join Date
- Feb 2015
- Location
- Flagstaff, AZ
- Posts
- 73
Manual bed leveling question.
So I am almost done with my build and have a question about bed leveling. Since all four corners have springs none of them are fixed, and if I choose one (say the back right side) and adjust the other corners using a piece of paper and the extruder head I still am not leveling off of a fixed reference because one z rod could have the nut a little higher or lower than the other so that when I move the extruder to the back left corner it could be going up or down. Should I use an actual level to level the bed and then adjust my left and right z rods to ensure that the x axis is level relative to the bed? Seems more like we are just assumeing the x axis is level and then we level the bed to it?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help