Results 1 to 4 of 4
Thread: CubePro - issue with PrintJet.
-
04-08-2015, 03:47 AM #1
- Join Date
- Feb 2015
- Posts
- 13
CubePro - issue with PrintJet.
Does anyone of you had similar issue as me (see the picture), the ABS plastic melted and stuck around the nozzle.
Is it possible to remove it? how ?
Regards
Last edited by aleksandra; 04-08-2015 at 03:49 AM. Reason: wrong viewing
-
04-08-2015, 04:21 AM #2
- Join Date
- Mar 2015
- Posts
- 5
if it still heats I would slowly heat it up and peel away any soft plastics..
If not heating up I would place it in the oven at 250 degrees and then peel it all away..
But I've never seen this before ..
-
04-08-2015, 05:18 AM #3
- Join Date
- Feb 2015
- Posts
- 13
Im worry about those cables, so that maybe put it in the boiled oil ?
-
04-08-2015, 05:28 AM #4
- Join Date
- Mar 2015
- Posts
- 5
?? oil ?? No not in oil .. just make sure the parts are hot around 200 degrees should be sufficient..
And all could be salvaged.. but not in oil.. just make sure the whole thing gets hot, therefore I mentioned the oven.. put it on a dish that you won't need anymore,no oil no nothing, just make it hot.... The insulation of the wires could suffer but that is an easy replace..
the Abs just needs to be soft or softer again!!
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion