Results 1 to 10 of 12
Thread: ABL Doesnt start
-
04-07-2015, 10:25 AM #1
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
ABL Doesnt start
These machines sometimes really confuse me.
it was working fine one minute and the next something changes.
right now for some reason, Auto Bed levelling doesnt run prior to a print
even though the G29 E code is in the startup script like it always was.
its enabled in Marlin
I have reflashed it.. restartred it..it just ignores the command.
-
04-07-2015, 10:33 AM #2
Are you sending the M502 followed by M500 commands after re-flashing?
-
04-07-2015, 10:43 AM #3
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
No I have never done that after reflashing. i also dont mess with the settings via the LCD Menu
I only adjust in marlin and reflash
-
04-07-2015, 10:46 AM #4
all it does it is clear and save to eeprom.
From Clough42's site
"All of our firmware is configured to save values in EEPROM so you can adjust values from the LCD. After uploading new firmware, you will need to reset the configuration to factory defaults and save these values to the EEPROM or the printer may behave strangely."
-
04-07-2015, 10:46 AM #5
- Join Date
- Nov 2014
- Posts
- 522
then make sure that eeprom is disabled just in case :-)
-
04-07-2015, 12:44 PM #6
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
I reflashed it again and it works now.
-
04-07-2015, 12:55 PM #7
- Join Date
- Nov 2014
- Posts
- 522
no telling... my display is borked atm... and i have flashed i couldnt tell you how many times... makes me wonder if i have a corrupt bit of nand
-
04-07-2015, 01:32 PM #8
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
makes me want one of those updated rambo boards
-
04-07-2015, 01:35 PM #9
-
04-07-2015, 01:42 PM #10
- Join Date
- Nov 2014
- Posts
- 522
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion