Results 11 to 15 of 15
Thread: Geared Z Steppers
-
04-06-2015, 06:58 AM #11
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
TMJ, what mount do you use for the MX switch on your printer?
-
04-06-2015, 09:38 AM #12
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
I tried setting it too 1/4 with 3200 steps but when I tried to move the Z axis it really skipped alot
when i set it to 1/8 with 6400 steps.. it was fine
on the LCD when i check the motion setting for the Z steps.. the display says +9999 for some reason
-
04-08-2015, 05:25 PM #13
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
Thanks for the suggestion on the MX Switch, i like them much more then the regular endstop microswitches, I also made up a servo probe arm to hole them.
http://www.thingiverse.com/thing:763048
-
04-08-2015, 05:51 PM #14
- Join Date
- Jul 2014
- Location
- Ontario, Canada
- Posts
- 257
-
04-08-2015, 06:49 PM #15
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
Cool. I had earlier asked if there was a servo mount for this type of switch.
It looks, though, that you might have some need of my caliper holder: http://www.thingiverse.com/thing:570778Last edited by AbuMaia; 04-10-2015 at 01:23 PM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion