Results 1 to 10 of 10
Thread: Printing without a raft?
Hybrid View
-
03-31-2015, 08:02 AM #1
This. I never use a raft, as it actually gave a worse surface than the glass, as you're finding out. And it's almost impossible to remove, although, that was before my new dremel. The sanding drums on the dremel are Very effective at removing support material, Although they tend to leave a smooth (flat? level?) rough surface (That makes no sense, but it's a smooth sanded surface). If you want a smooth finish, then acetone is required, but since the layers are sanded off, the finish is smoother and quicker. Sorry, went off on a tangent there. Nope, hate rafts.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help