Results 1 to 10 of 18
Threaded View
-
03-24-2015, 04:03 PM #6
Hi
Thank you for the post
The manufacturer actually recommends 22 degrees C so I didn't want to advertise anything above that. The heater has been designed to heat up to 40 degrees C and it has its own plug in the machine so it won't influence the rest of the electronics. I had my resin at 35 degrees C for 6 months and the resin was fine. Actually the living room gets around 30 degrees during the day, but if I advertise that and people have issues then I might get into trouble because I go against the manufacturer recommendations
Kobus
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion